ShotStop Duritium Special Threat Plates
September 14, 2018 at 12:00 pm #108208
Guys, are you tracking that MVT became a dealer for the ShotStop Duritium ballistic plates? I just sent out all my initial stock to customers.
These are the first plates that I have truly gotten excited about, and now the ones I wear in my plate carrier. So much so, I became a dealer!
These are the best plates on the market, they are not ceramic / dyneema but made of duritium / metal alloy. As such they do not suffer from heat such as locked in a car like Dyneema, or cracking like ceramic. Ground breaking technology.
I have focussed on the special threat green tip plates, and that is what I have in my carrier, and what I had in stock. Use coupon code maxprotect in the shopping cart for a 5% discount.
However, take a look at shotstop.net: I can order in any of the plates they offer. Just email me and I will get you a price.
I’m considering my next stock order, so of you have interest either let me know or simply purchase from the gear store for the green tip special threat plates. Yes, we can do different sizes, side plates etc, you just need to email me for a price if it is not in the gear store.
Any questions, let me know.
September 14, 2018 at 7:13 pm #108209
September 14, 2018 at 7:49 pm #108210
Who is coming to me for the best ballistic plates out there?
As soon as I decide between the Duritium III GT Body Armor Plates and the Duritium IV HS Body Armor Plates.
Do I need level IV?
In the past I have bought IV plates just for that little bit extra warm and fuzzy.
I had been considering Bulletproofme.com’s light weight IV plates, but they were three times the cost of ShotStops.
It might have been a easier decision, but the ShotStops IV are slightly cheaper than III on another vendors site. Haven’t got you to check price on them as yet, but since you got in the mix, I’ll purchase from you once decided.
September 14, 2018 at 8:02 pm #108211
looks like the Iv are a little cheaper, but heavier at 5.5 lb. What was the price you saw? Where? What were they doing the III GT for?
September 14, 2018 at 8:42 pm #108212
looks like the Iv are a little cheaper, but heavier at 5.5 lb.
That compromise thing!
The IV’s are also a single curve SAPI CUT 10″ X 12″ X .9″ (large is only size) at other site $365
Which I am comparing to the III GT – 10″x12″x.55″ – Multi-Curve, SAPI/ESAPI Cut (SE) at $420 on other site.
September 14, 2018 at 8:48 pm #108213
Let me look at it. But they are $5 more than MVT on the GT, so I should be able to do the IV for $5 less @ $360.
September 14, 2018 at 8:52 pm #108214
Even if you just matched price I would go with you once I decide for sure on which plates to get.
September 15, 2018 at 5:51 pm #108215
May 30, 2019 at 11:31 am #108216wheelseeParticipant
Ran across this video…….
Yes, I realize not the exact same as what Max demonstrated but still available
- You must be logged in to reply to this topic.